Timer Class Timer Assignment - NEC Univerge SV8100 Programming Manual

Digitcom Canada Inc. Need Support? Call 1-866-667-8357 Visit us at: www.digitcom.ca
Issue 1.0
Level:
IN
Description
Use Program 20-31 : Timer Class Timer Assignment to assign values to the timers
on a class of service basis.
Input Data
Item
No.
01
Trunk Queuing Callback Duration Time
Trunk Queuing Callback rings an extension for
this amount of time
02
Callback / Trunk Queuing Cancel Time
The system cancels an extension Callback or
Trunk Queueing request after this amount of
time.
03
CAR/SIE/Virtual Extension Delay Interval
CAR Keys/SIE Keys/Virtual Extensions set for
Delayed Ringing (refer to
Extension Delayed Ring
extension after this interval.
04
Intercom Interdigits Time (Intercom I/D
Timer)
When placing Intercom calls, extension users
must dial each digit in this time.
05
Trunk Interdigits Time (Trunk I/D Timer)
The system waits for this time to expire before
placing the call in a talk state (Call Timer starts
after time expires, Voice Over and Barge-In are
not allowed until after time expires).
06
Hotline Time Start Time (Hotline Start)
A Ringdown extension automatically calls the
programmed destination after this time.
2 - 250
Program 20 : System Option Setup

20-31 : Timer Class Timer Assignment

Timer Class Number
Item
15-11 : Virtual
Assignment) ring the
Input Data
0~64800 seconds 15 seconds
0~64800 seconds 64800 seconds
0~64800 seconds 10 seconds
0~64800 seconds 10 seconds
0~64800 seconds
0~64800 seconds
Program 20 : System Option Setup
UNIVERGE SV8100
0~15
Related
Default
Programming
20-01-08
20-01-09
20-04-03
21-01-02
5 seconds 21-01-03
5 seconds 21-01-09