Checking Circuit Pack Configuration - Avaya G650 Installing

Testing the complete configuration
Figure 101: Sample port network status screen for Cabinet 1—Avaya S8700 Multi-
Connect
status port-network 1
Major Minor
PN Alarms Alarms Alarms
1 1
TDM Service
Bus State
A in
B in
Command:

Checking circuit pack configuration

The list configuration report provides a list of circuit packs connected to the configuration and recognized
by the software. To check circuit pack configuration:
1
Type list configuration all
2
Verify the screen displays list configuration similar to
screen — Page 4, Avaya S8700 Multi-Connect, on page
communicating with each circuit pack (except power supply circuit packs). Do not attempt to
correct any problems until after the diagnostic tests that you run later in the configuration tests.
3
Note any boards with a VINTAGE column entry of NO BOARD or CONFLICT.
A u indicates unassigned ports, and a number indicates the port has been translated.
210
PORT NETWORK STATUS
Warning Carrier
Locs Active
0 195 01A up
01B
Control Dedicated
Channel Tones
y n
n y
Service Major
PKT State Alarms
1 in n
and press Enter.
PN Control FIBER-
Standby LINK
up 1 B-PNC 01B02-03E04 standby
1 A-PNC 01A01-01E04 active
TONE/ Service
CLOCK State
01B in
01A in
Minor Bus Open Bus
Alarms Faults Leads
n 0 0
Figure 102, Sample system configuration
211. Make sure the software is
Installing the Avaya G650 Media Gateway
Endpoints Mode
System System
Clock Tones
standby standby
active active
June 2004