Removing A Console Or Auxiliary Cable; Installing A Console Or Auxiliary Cable; Figure 108: Serial Port Connector - Juniper TX MATRIX PLUS Hardware Manual

Copyright © 2010, Juniper Networks, Inc.

Removing a Console or Auxiliary Cable

To remove a cable from the console or auxiliary port:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Turn off the power to the console or auxiliary device.
2.
Pull the cable connector straight out of the port.
3.
Disconnect the cable from the console or auxiliary device.
4.

Installing a Console or Auxiliary Cable

To connect to a management console or auxiliary device:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Plug the female end of the replacement serial cable into the appropriate
2.
or port (see Figure 108 on page 335). Figure 109 on page 336 shows the external
AUX
device ports on the TXP-CB.
Power on the auxiliary or console device.
3.

Figure 108: Serial Port Connector

Chapter 22: Replacing TX Matrix Plus Hardware Components
CONSOLE
335