Installing The Rear Cable Management System Arms; Figure 69: Installing The Tx Matrix Plus Cable Management System Shelves And - Juniper TX MATRIX PLUS Hardware Manual

TX Matrix Plus Router Hardware Guide

Installing the Rear Cable Management System Arms

154
NOTE: It is easiest to tighten these screws if the pivoting arm brackets
are in the service position.
Repeat for the remaining shelves.
4.
Figure 69: Installing the TX Matrix Plus Cable Management System
Shelves and Arms
CMS support
shelves
To install the rear cable management system arms:
Identify the left cable management arms and right cable management arms.
1.
Attach each cable management arm with three screws on top and three screws on
2.
bottom of each arm.
Comb assembly
support
Copyright © 2010, Juniper Networks, Inc.