Table of Contents
Advertisement
Related
Documentation
Installing the TX Matrix Plus Front Cable Manager
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Move the upper and lower brackets for the upper right cable management arm into
3.
the service position. Repeat for the lower right cable management arm, and for both
left cable management arms.
Position one of the right cable management arms onto the brackets, and install with
4.
three of the supplied Phillips screws into the upper bracket, and three of the supplied
Phillips screws into the lower bracket.
TX Matrix Plus Switch-Fabric Chassis Description on page 8
TX Matrix Plus Rear Cable Management System on page 49
The front cable manager is a single-piece unit that is installed just below the CIP slots
on the front of the chassis.
Engage the upper tab into a slot in the wall that separates the CIP and TXP-F2 SIB
1.
card cages.
Tighten the two captive screws in the front cable manager.
2.
TX Matrix Plus Switch-Fabric Chassis Description on page 8
TX Matrix Plus Cables Overview on page 48
TX Matrix Plus Front Cable Manager on page 53
Chapter 11: Installing the TX Matrix Plus Router Using a Mechanical Lift
155
Advertisement
Table of Contents
Troubleshooting
