Table 4: Txp-F13 Sib Leds; Table 5: F13-Sib Port Leds - Juniper TX MATRIX PLUS Hardware Manual

TX Matrix Plus Router Hardware Guide

Table 4: TXP-F13 SIB LEDs

Label Color
Green
ACTIVE
–
OK Green
–
Yellow
FAIL
–

Table 5: F13-SIB Port LEDs

Label Color
Green
LINK
Yellow
Red
–
Green
RxPWR
Yellow
–
16
State Description
On steadily TXP-F13 SIB is in active mode and actively passing traffic.
Off TXP-F13 SIB is either offline or not actively passing traffic.
On steadily TXP-F13 SIB is functioning normally.
Off TXP-F13 SIB is offline or not seated properly.
On steadily TXP-F13 SIB has failed.
Off No faults have been detected for the TXP-F13 SIB.
The port LEDs are located next to the ports. Table 5 on page 16 describes the functions
of these LEDs.
State
On steadily
Blinking
On steadily
Blinking
On steadily
Off
On steadily
On steadily
Off
Description
The link between the TXP-F13 SIB port and the TXP-T1600 SIB
port has been established successfully.
The link between the TXP-F13 SIB port and the loopback
connector has been established successfully.
The link is being established.
The fiber-optic array cable might be connected to either the
wrong TXP-T1600 SIB port or wrong TXP-FI3 port.
The link between the TXP-F13 SIB port and the TXP-T1600 SIB
port failed. There might be a hardware problem, or the fiber-optic
port or cable might need to be cleaned.
The cable is not connected on both sides, or either the TXP-F13
SIB or TXP-T1600 SIB is powered off.
Full optical power is being received.
Diminished optical power is being received. The fiber-optic array
cable or the fiber-optic array port might need cleaning, or the
cable might be damaged.
No optical power has been received. The fiber-optic array cable
is not connected to the TXP-FI3 SIB port, or not connected to
the TXP-T1600 SIB port. If the cable is connected on both sides,
the cable might be cut.
Copyright © 2010, Juniper Networks, Inc.