Juniper TX MATRIX PLUS Hardware Manual page 329

Copyright © 2010, Juniper Networks, Inc.
2/0 Online
2/2 Online
2/4 Online
2/6 Empty
3/0 Empty
3/2 Empty
3/4 Empty
3/6 Empty
4/0 Empty
4/2 Empty
4/4 Empty
4/6 Empty
lcc0-re0:
--------------------------------------------------------------------------
Slot State
0 Check
1 Disconnected
2 Disconnected
3 Disconnected
4 Disconnected
Make sure the TXP-F13 SIB is properly seated in the midplane. Verfiy that each ejector
3.
handle has been turned clockwise and is tight.
user@host> show chassis environment sib sfc 0
sfc0-re0:
--------------------------------------------------------------------------
SIB F13 0 status:
State
Temperature
Temperature (B)
Power
1.2 V_0
1.2 V_1
1.2 V_2
1.2 V_3
1.5 V_0
1.5 V_1
1.8 V
2.5 V
3.3 V
9.0 V
9.0 V bias
Power (B)
2.5 V
3.3 V
9.0 V
SIB F13 1 status:
State
Temperature
Temperature (B)
Power
1.2 V_0
1.2 V_1
1.2 V_2
1.2 V_3
1.5 V_0
1.5 V_1
1.8 V
2.5 V
Chapter 21: Troubleshooting TX Matrix Plus Hardware Components
SIB F2S 4 hours, 2 minutes, 20 seconds
SIB F2S 4 hours, 2 minutes, 19 seconds
SIB F2S 4 hours, 2 minutes, 18 seconds
Uptime
4 hours, 1 minute, 34 seconds
4 hours, 2 minutes, 11 seconds
4 hours, 2 minutes, 1 second
4 hours, 1 minute, 52 seconds
4 hours, 1 minute, 43 seconds
Online - Standby
53 degrees C / 127 degrees F
49 degrees C / 120 degrees F
1198 mV
1202 mV
1202 mV
1195 mV
1495 mV
1498 mV
1804 mV
2510 mV
3300 mV
9000 mV
0 mV
2497 mV
3306 mV
9048 mV
Online - Standby
46 degrees C / 114 degrees F
41 degrees C / 105 degrees F
1195 mV
1198 mV
1198 mV
1189 mV
1498 mV
1492 mV
1804 mV
2500 mV
295