Verifying The State Of The Routing Matrix Control Plane - Juniper TX MATRIX PLUS Hardware Manual

TX Matrix Plus Router Hardware Guide

Verifying the State of the Routing Matrix Control Plane

Purpose
Action
246
After the T1600 router has booted, verify the state of the the routing matrix control plane.
To verify that the routing matrix control plane is operating correctly:
Issue the
1. show chassis ethernet-switch sfc 0
Verify that the link to the T1600 router (
good on GE port 2 connected to device: LCC1
NOTE: The throughput of the control plane connections between the TX
Matrix Plus router and the T1600 routers is 1000 Mbps. The throughput
of the connections between Routing Engines in a TX Matrix Plus router is
10 Gbps.
user@host> show chassis ethernet-switch sfc 0
sfc0-re0:
--------------------------------------------------------------------------
Displaying summary for switch 0
Link is good on XE port 1 connected to device: 1GSW
Speed is 10000Mb
Duplex is full
Autonegotiate is Disabled
Link is good on XE port 9 connected to device: RE1
Speed is 1000Mb
Duplex is full
Autonegotiate is Disabled
Link is good on XE port 17 connected to device: RE0
Speed is 1000Mb
Duplex is full
Autonegotiate is Disabled
Displaying summary for switch 1
Link is good on GE port 0 connected to device: LCC0
Speed is 1000Mb
Duplex is full
Autonegotiate is Enabled
command.
) is . For example,
LCClcc-number good
.
Copyright © 2010, Juniper Networks, Inc.
Link is