Tx Matrix Plus Junos Operational Overview - Juniper TX MATRIX PLUS Hardware Manual

TX Matrix Plus Router Hardware Guide

TX Matrix Plus Junos Operational Overview

74
the TX Matrix Plus router supports group names for the Routing Engines in each T1600
router in the following formats:
lcc lcc-number -re0
lcc lcc-number-re1
identifies the T1600 router and can be from 0 through 3.
lcc-number
For example, to configure Routing Engine 1 properties for
at the [edit groups lcc3-re1]
You must include the
apply-groups
including re0 and re1 .
The CLI includes commands for monitoring and troubleshooting hardware, software,
routing protocols, and network connectivity. CLI commands display information from
routing tables, information specific to routing protocols, and information about network
connectivity derived from the
In general, a routing matrix with a TX Matrix Plus router and T1600 routers supports most
of the same Junos operational mode commands that run on all Juniper Networks J Series,
M Series, MX Series, and T Series routers, including TX Matrix routers. The operation of
a routing matrix is the same as for all other Juniper Networks routers, with the following
exceptions:
A new management Ethernet interface
The new sfc interface for the TX Matrix Plus router. When you specifiy the
you must use the expanded range of FPC numbers for interfaces.
The interface is now supported for T1600 routers in a routing matrix.
lcc
NOTE: The
lcc
a TX Matrix router.
Additional commands and options have been added to support enhanced diagnostics
features for the fiber-optic links and other new hardware in the TX Matrix Plus router
For more information about operational mode commands, see the Junos OS command
references.
You can also use the Junos OS implementation of SNMP to monitor routers. The SNMP
software consists of an SNMP master agent and a MIB II agent. It provides full support
for MIB II SNMP version 1 traps and version 2 notifications, SNMP version 1
requests, and version 2
GetBulk
Junos OS Network Management Configuration Guide.
hierarchy level.
statement in the configuration for all special groups,
and utilities.
ping traceroute
em0
interface is also supported for T640 routers connected to
requests. For more information about SNMP, see the
, you include statements
lcc3
sfc option,
Get and GetNext
Copyright © 2010, Juniper Networks, Inc.