Index - Juniper TX MATRIX PLUS Hardware Manual

Index

Symbols
#, comments in configuration statements.................xxxi
( ), in syntax descriptions..................................................xxxi
< >, in syntax descriptions................................................xxxi
[ ], in configuration statements......................................xxxi
{ }, in configuration statements......................................xxxi
| (pipe), in syntax descriptions........................................xxxi
A
accessory box
parts list.............................................................................113
removing...........................................................................112
agency approvals.................................................................425
air filter
routine inspection of..................................................266
air filters
maintaining...................................................................266
replacing.........................................................................349
airflow
required clearance around chassis for.................108
alarms
handling by Routing Engine........................................25
LEDs (red and yellow) on craft interface..............33
messages, list of...........................................................277
mode for LCD display....................................................31
relay contacts..................................................................38
wire specifications.............................................444
temperature, displaying............................................283
altitude, acceptable range................................................433
antistatic mat, using............................................................392
approvals, agency................................................................425
architecture
control plane
TX Matrix Plus router...........................................56
switch fabric
routing matrix.........................................................60
auxiliary port.............................................................................23
Copyright © 2010, Juniper Networks, Inc.
auxiliary port (for Routing Engine management)
cable
connection during initial installation...........160
replacement instructions................................334
specifications.......................................................443
cable connector pinouts (RJ-45)..........................446
B
battery
environmental compliance.....................................429
lithium..............................................................................429
booting the TX Matrix Plus router....................................171
braces, in configuration statements.............................xxxi
brackets
angle, in syntax descriptions...................................xxxi
square, in configuration statements....................xxxi
C
cable
auxiliary or console port (for Routing Engine
management)
connecting during initial installation...........160
replacing................................................................334
DB-9 serial.......................................................................48
Ethernet port (for Routing Engine
management)
connecting during initial installation............158
replacing.................................................................332
Fiber-optic array.............................................................48
fiber-optic array
site preparation....................................................109
grounding See grounding cables
UTP Category 5..............................................................48
cable management system
install..................................................................................151
case number, for JTAC........................................................454
chassis...........................................................................................8
alarm messages See alarm, messages
dimensions..........................................................................8
ESD points......................................................8, 393, 394
grounding points...............................................................11
461