Verifying The State Of The Tx Matrix Plus And T1600 Router; Overview Of Verifying The State Of A Routing Matrix - Juniper TX MATRIX PLUS Hardware Manual

CHAPTER 19
Verifying the State of the TX Matrix Plus
and T1600 Router
Overview of
Verifying the State of a Routing Matrix
Purpose
Action
Copyright © 2010, Juniper Networks, Inc.
Overview of Verifying the State of a Routing Matrix on page 245
Verifying the State of the Routing Matrix Control Plane on page 246
Verifying That the FPCs on the T1600 Router Are Detected and Online on page 247
Verifying the State of the Interfaces on a T1600 Router on page 250
Verifying the State of the Switching Planes in the Routing Matrix on page 251
Verifying the State of the Links in the Routing Matrix on page 258
To verify that you have successfully completed the integration procedure, verify that the
state of the control planes, switching planes, and interfaces is correct.
NOTE: Before you can issue the verification commands, you must be running
the Junos OS Release 9.6R2 and later.
Verify the state of the routing matrix control plane.
1.
See "Verifying the State of the Routing Matrix Control Plane" on page 246.
Verify that the FPCs on the T1600 routers are detected and online.
2.
See "Verifying That the FPCs on the T1600 Router Are Detected and Online" on page 247.
Verify the state of the routing matrix switching planes.
3.
See "Verifying the State of the Switching Planes in the Routing Matrix" on page 251.
Verify the state of the links in the routing matrix.
4.
See "Verifying the State of the Links in the Routing Matrix" on page 258.
Verify the state of the interfaces on all the T1600 routers in the routing matrix.
5.
See "Verifying the State of the Interfaces on a T1600 Router" on page 250.
245