M320 Multiservice Edge Router Hardware Guide
Replacing an M320 Console or Auxiliary Cable
Removing an M320 Console or Auxiliary Cable
194
Removing an M320 Console or Auxiliary Cable on page 194
1.
Installing an M320 Console or Auxiliary Cable on page 195
2.
To remove a serial cable connected to a management console or auxiliary device (see
Figure 70 on page
195):
Turn off the power to the console or auxiliary device.
1.
Unscrew the screws that secure the cable connector to the port, using a 2.5-mm
2.
flat-blade screwdriver if necessary.
Pull the cable connector straight out of the port.
3.
Disconnect the cable from the console or auxiliary device.
4.
Copyright © 2015, Juniper Networks, Inc.