Returning To The Original T1600 Configuration - Juniper TX MATRIX PLUS Hardware Manual

TX Matrix Plus Router Hardware Guide

Returning to the Original T1600 Configuration

320
NOTE: Ensure that the ejector handle tabs are properly mated inside their
corresponding chassis slots before you tighten the captive screws on the
ejector handles. You might have to close and open the handles a few times
before the tabs catch the slots.
To return to the original T1600 configuration:
Set the M/S switch on each LCC-CB on the T1600 router faceplate to
1.
On an external management device connected to the console or auxiliary port of the
2.
T1600 CIP, load the original T1600 router configuration. For example:
user@host# load override t1600-config.conf
If graceful switchover is enabled in the original T1600 router configuration, disable it
3.
as follows:
user@host# delete chassis redundancy graceful-switchover
Issue the
commit synchronize
4.
errors:
user@host# commit synchronize
On an external management device connected to the console or auxiliary port of
5.
, reboot the corresponding Routing Engine in the T1600 router:
T1600-CIP-0
user@host> request system reboot
On an external management device connected to the console or auxiliary port of
6.
, reboot the corresponding Routing Engine in the T1600 router:
T1600-CIP-1
user@host> request system reboot
Display the status of the SIBs by issuing the
7.
Routing Engine:
user@host> show chassis sibs
Slot State
0 Spare
1 Online
2 Online
3 Online
4 Online
Verify that four SIBs are in the
Delete all statements associated with
8.
configuration. To review the T1600 router configuration changes that were merged
into the TX Matrix Plus router configuration, see "Creating a Configuration File for the
Integration of an Operational T1600 Router" on page 210.
command and ensure that there are no synchronization
show chassis sibs
Uptime
255 days, 31 minutes, 12 seconds
255 days, 31 minutes, 12 seconds
255 days, 31 minutes, 12 seconds
255 days, 31 minutes, 12 seconds
255 days, 31 minutes, 12 seconds
state and one SIB is in the
Online
LCC0 from the TX Matrix Plus router
Copyright © 2010, Juniper Networks, Inc.
S .
command on the master
state.
Spare