Replacing Chassis Components; Replacing An Mx104 Console Or Auxiliary Cable; Removing An Mx104 Console Or Auxiliary Cable; Figure 35: Ethernet Cable Connectors - Juniper MX104 Hardware Manual

CHAPTER 19

Replacing Chassis Components

Replacing an MX104 Console or Auxiliary Cable

Removing an MX104 Console or Auxiliary Cable

Copyright © 2017, Juniper Networks, Inc.
Replacing an MX104 Console or Auxiliary Cable on page 137
Replacing an MX104 Management Ethernet Cable on page 138
Replacing an MX104 Fiber-Optic Cable on page 139
Replacing an MX104 Alarm Cable on page 141
NOTE: The
AUX
Removing an MX104 Console or Auxiliary Cable on page 137
1.
Installing an MX104 Console or Auxiliary Cable on page 138
2.
To remove a serial cable connected to a console or auxiliary device:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Press the tab on the connector, and pull the connector straight out of the
2.
port. Figure 35 on page 137
CONSOLE
Disconnect the cable from the console or auxiliary device.
3.

Figure 35: Ethernet Cable Connectors

port is not supported.
shows the connector.
AUX or
137