Figure 261: Installing a Routing Engine into a Control Board
Replacing a PTX5000 Management Console or Auxiliary Port Cable
IN THIS SECTION
Removing a Management Console or Auxiliary Port Cable | 489
Installing a Management Console or Auxiliary Port Cable | 490
Removing a Management Console or Auxiliary Port Cable
To remove a cable from the console or auxiliary port (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Turn off the power to the console or auxiliary device.
3. Pull the cable connector straight out of the port.
Figure
16):
489