M10i Multiservice Edge Router Hardware Guide
142
All manuals and user guides at all-guides.com
Figure 62: Console and Auxiliary Ports
1.
Removing an M10i Console or Auxiliary Cable on page 142
Installing an M10i Console or Auxiliary Cable on page 142
2.
Removing an M10i Console or Auxiliary Cable
To remove a cable from the
Turn off the power to the console or auxiliary device.
1.
Unscrew the screws that secure the cable connector to the port, using a 2.5-mm
2.
flat-blade screwdriver if necessary.
Pull the cable connector straight out of the port.
3.
Disconnect the cable from the console or auxiliary device.
4.
Installing an M10i Console or Auxiliary Cable
Plug the female end of the replacement serial cable into the
1.
Figure 62 on page 142 shows the ports on the Routing Engine.
Tighten the screws on the connector, using a 2.5-mm flat-blade screwdriver if
2.
necessary.
Power on the auxiliary or console device.
3.
CONSOLE
or
AUX
port:
or
CONSOLE
AUX
Copyright © 2010, Juniper Networks, Inc.
port.