Installing The Rear Cable Management System Comb Assembly - Juniper TX MATRIX PLUS Hardware Manual

TX Matrix Plus Router Hardware Guide

Installing the Rear Cable Management System Comb Assembly

152
Upper cable management shelf
Middle cable management shelf
Lower cable management shelf
Comb assembly
Comb assembly left support
Comb assembly right support
Two left cable management arms
Two right cable management arms
24 Phillips screws provided in the accessory box.
Velcro straps provided in the accessory box.
To install the comb assembly (see Figure 68 on page 153).
Assemble together the left and right comb assembly supports with the comb panel
1.
assembly with the four of the supplied Phillips screws.
Align the four captive screws on the comb assembly with the mounting holes at the
2.
top of the chassis (immediately above the TXP-F13 SIB card cage). Secure the cable
assembly to the chassis to the top of the chassis by tightening each of the captive
screws.
Copyright © 2010, Juniper Networks, Inc.