CHAPTER 5
T1600 Router Overview
Hardware Requirements for a T1600 Router in a Routing Matrix with a TX Matrix Plus
Router
Copyright © 2010, Juniper Networks, Inc.
Hardware Requirements for a T1600 Router in a Routing Matrix with a TX Matrix Plus
Router on page 89
The routing matrix can be configured with one to four converted T1600 routers. Figure
37 on page 90 and Figure 38 on page 91 illustrate the front and rear of a T1600 router.
Before you integrate a T1600 router into a routing matrix, you must install the following
hardware components:
Rear fan tray—An upgraded rear fan tray (part number 760-024613) is required to cool
the LCC chassis. Part number 760-009870 is not supported for a T1600 router in a
routing matrix.
Two LCC-CBs (CB-LCC-BB).
Two C1800 Routing Engines (RE-TXP-DUO-C1800-8G-BB).
Five TXP-T1600 SIBs (SIB-TXP-T1600).
If needed, two three-input 240-A power supplies or four-input 240-A power supplies.
An upgraded three-input 240-A power supply (part number 740-026384) or a
four-input 240-A power supply is required. The three-input 240-A power supply (part
number 740-017906) is not supported for a T1600 router in a routing matrix.
The hardware upgrade kit includes two LCC-CBs and five TXP-T1600 SIBs. The Routing
Engines must be ordered separately. The rear fan tray and power supplies, if needed, can
also be ordered separately. For information about installing a new T1600 router, see the
T1600 Core Router Hardware Guide.
89