Installing An Acx4000 Management Ethernet Cable; Replacing An Acx4000 Console Or Auxiliary Cable; Removing An Acx4000 Console Or Auxiliary Cable - Juniper ACX4000 Hardware Manual

SEE ALSO
Replacing an ACX4000 Management Ethernet Cable | 131
Management Port Connector Pinout Information for ACX Series Routers | 89

Installing an ACX4000 Management Ethernet Cable

To install a serial cable connected to a management device:
1. Attach an ESD grounding strap to your bare wrist, and connect the other end of the strap to an ESD
grounding point.
2. Plug one end of the replacement cable into the appropriate MGMT port.
3. Plug the other end of the cable into the network device.
SEE ALSO
Replacing an ACX4000 Management Ethernet Cable | 131
Management Port Connector Pinout Information for ACX Series Routers | 89
RELATED DOCUMENTATION
Management Port Connector Pinout Information for ACX Series Routers | 89

Replacing an ACX4000 Console or Auxiliary Cable

IN THIS SECTION

Removing an ACX4000 Console or Auxiliary Cable | 132

Installing an ACX4000 Console or Auxiliary Cable | 133
Removing an ACX4000 Console or Auxiliary Cable
To remove a serial cable connected to a console or auxiliary device:
1. Attach an ESD grounding strap to your bare wrist, and connect the other end of the strap to an ESD
grounding point.
132