Replacing A Txp-F2S Sib; Removing A Txp-F2S Sib; Figure 127: Installing A Txp-F13 Sib - Juniper TX MATRIX PLUS Hardware Manual

TX Matrix Plus Router Hardware Guide
Related
Documentation

Replacing a TXP-F2S SIB

370

Figure 127: Installing a TXP-F13 SIB

TX Matrix Plus TXP-F13 SIB Overview on page 13
TX Matrix Plus TXP-F13 SIB LEDs on page 15
TXP-F13 SIB LEDs on the TX Matrix Plus Craft Interface on page 34
Troubleshooting the TX Matrix Plus SIBs on page 294
Cleaning Fiber-Optic Array Components with the Dry Cloth Cleaning Tool on page 271
TX Matrix Plus Preventing Electrostatic Discharge Damage on page 392
Removing a TXP-F2S SIB on page 370
1.
Installing a TXP-F2S SIB on page 372
2.

Removing a TXP-F2S SIB

The TXP-F2S SIBs are located in the front of the chassis in slots
TXP-F2S SIB weighs approximately 3.4 lb (1.5 kg).
TXP-F2S SIBs are hot-insertable and hot-removable. When you remove a TXP-F2S SIB,
traffic forwarding continues without any degradation as long as four TXP-F2S SIBs remain
in the chassis.
To remove a TXP-F2S SIB (see Figure 128 on page 371):
Have ready an antistatic mat for the TXP-F2S SIB, and one dust cover for each
1.
fiber-optic array cable you remove from the TXP-F2S SIB.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Use one of the following methods to take the TXP-F2S SIB offline:
3.
Issue the following CLI command:
SIB0 through SIB15
Copyright © 2010, Juniper Networks, Inc.
. Each