MX104 3D Universal Edge Router Hardware Guide
Replacing an MX104 Console or Auxiliary Cable
86
Disconnect the cable from the network device.
3.
Installing an MX104 Clocking or Timing Cable
To remove a cable connected to a clocking or timing device:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Plug one end of the replacement cable into the appropriate port.
2.
Plug the other end of the cable into the network device.
3.
NOTE:
The
AUX
Removing an MX104 Console or Auxiliary Cable on page 86
1.
Installing an MX104 Console or Auxiliary Cable on page 86
2.
Removing an MX104 Console or Auxiliary Cable
To remove a serial cable connected to a console or auxiliary device:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Press the tab on the connector, and pull the connector straight out of the
2.
port.
Figure 24 on page 86
CONSOLE
Disconnect the cable from the console or auxiliary device.
3.
Figure 24: Ethernet Cable Connectors
Installing an MX104 Console or Auxiliary Cable
The
CONSOLE
port on the front panel of the router accepts an RS-232 (EIA-232) serial
cable with RJ-45 connectors.
NOTE:
The
AUX
To connect a cable between the router and the console or auxiliary device:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
port is not supported.
shows the connector.
port is not supported.
AUX
Copyright © 2014, Juniper Networks, Inc.
or