Table of Contents
Advertisement
CHAPTER 14
Configuring the TX Matrix Plus Router
Preparing to Configure the TX Matrix Plus Router
Related
Documentation
Performing the Initial Software Configuration for the TX Matrix Plus Router
Copyright © 2010, Juniper Networks, Inc.
Preparing to Configure the TX Matrix Plus Router on page 175
Performing the Initial Software Configuration for the TX Matrix Plus Router on page 175
Configuring Specific LCC Chassis Features for T1600 Routers on page 179
Configuring a T1600 Router to Be Offline on page 179
Configuring the TX Matrix Plus Router to Generate an Alarm if the T1600 Routers in
the Routing Matrix Do Not Come Online on page 180
Gather the following information before configuring the TX Matrix Plus router:
Name the TX Matrix Plus router will use on the network
Domain name the TX Matrix Plus router will use
IP address and prefix length information for the Ethernet interface
IP address of a default TX Matrix Plus router
IP address of a DNS server
Password for the root user
TX Matrix Plus CLI Overview on page 72
Performing the Initial Software Configuration for the TX Matrix Plus Router on page 175
These procedures connect a TX Matrix Plus router to the network but do not enable it to
forward traffic. For complete information about enabling the router to forward traffic,
including examples, see the Junos OS configuration guides.
You configure the TX Matrix Plus router by issuing Junos OS command-line interface
(CLI) commands, either on a console device attached to the
TXP-CB, or over a telnet connection to a network connected to the
the TXP-CB.
port on the
CONSOLE
port on
ETHERNET
175
Advertisement
Table of Contents
Troubleshooting
