Tx Matrix Plus Hardware Component Overview - Juniper TX MATRIX PLUS Hardware Manual

Hide thumbs Also See for TX MATRIX PLUS:

Table of Contents

The chassis includes the following features (see Figure 2 on page 10 and Figure 3 on

A pair of metal front-mounting flanges used to mount the chassis in a four-post rack.

A pair of metal center-mounting brackets used to mount the chassis in an open-frame

Upper and lower handles on each side to facilitate positioning the TX Matrix Plus router

in the rack. Do not use the handles to lift the TX Matrix Plus router.

Four electrostatic discharge points (banana plug receptacles), two in the front above

and below the left front air filters and two in the rear near the right rear fan trays.

WARNING: Before removing or installing components of a TX Matrix Plus

router, attach an ESD strap to an ESD point and place the other end of the

strap around your bare wrist. Failure to use an ESD strap could result in

damage to the TX Matrix Plus router.

The TX Matrix Plus router must be connected to earth ground during normal

Chapter 2: TX Matrix Plus Hardware Component Overview

Troubleshooting