Removing The Front Fan Trays; Figure 54: Removing The Txp-F13 Sibs - Juniper TX MATRIX PLUS Hardware Manual

Removing the Front Fan Trays

Copyright © 2010, Juniper Networks, Inc.
Grasp both ejector handles, pull firmly, and slide the TXP-F13 SIB about three-quarters
4.
of the way out of the chassis.
CAUTION: Be prepared to support the weight of the TXP-F13 SIB before
you slide it completely out of the chassis.
When the TX-SIB is out of the chassis, do not hold it by its ejector handles
or edge connectors. They cannot support its weight.
Place one hand underneath the TXP-F13 SIB to support it, and slide it completely out
5.
of the chassis. Place it on the antistatic mat.
CAUTION: Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
Repeat the procedure for each of the remaining TXP-F13 SIBs.
6.

Figure 54: Removing the TXP-F13 SIBs

Two front fan trays are located above and below the TXP-F2S SIBs in the front of the
chassis. Each front fan tray weighs about 9.0 lb (4.0 kg).
To remove the front fan trays (see Figure 55 on page 134):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point.
Loosen the captive screws on the corners of the faceplate.
2.
Grasp the handle and pull the fan tray until it stops (approximately 1.5 in.).
3.
Press the release latch located on the left side of the fan tray.
4.
Chapter 11: Installing the TX Matrix Plus Router Using a Mechanical Lift
133