Connecting A Control Plane Cable; Replacing A Management Ethernet Cable; Figure 105: Removing A Control Plane Cable - Juniper TX MATRIX PLUS Hardware Manual

TX Matrix Plus Router Hardware Guide
Related
Documentation

Replacing a Management Ethernet Cable

332

Figure 105: Removing a Control Plane Cable

ONLINE/OFFLINE
button
Status LEDs
LCC Control
plane ports
SFC Control
plane ports
Alarm relay
connectors
SP EE D:

Connecting a Control Plane Cable

To connect a control plane cable:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Plug one end of the replacement cable into the appropriate TXP-CIP port.
2.
Plug the other end of the cable into the port labeled
3.
LCC-CB on the T1600 router.
Arrange the cable appropriately.
4.
TX Matrix Plus Cables Overview on page 48
Routing Matrix with a TX Matrix Plus Router System Control Plane Architecture on
page 56
TX Matrix Plus Preventing Electrostatic Discharge Damage on page 392.
Removing the Managment Ethernet Cable on page 333
1.
Installing the Management Ethernet Cable on page 333
2.
NC
C
NO
NC
C
NO
YE L=1
0/1 00
GR N= 100
0
on the corresponding
SFC0
Copyright © 2010, Juniper Networks, Inc.