Table of Contents
Advertisement
Fan trays
Copyright © 2010, Juniper Networks, Inc.
Figure 114: Removing the Rear Fan Tray
Installing a TX Matrix Plus Rear Fan Tray
To install a replacement rear fan tray (see Figure 115 on page 346):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Grasp the fan tray handle and insert it straight into the chassis.
2.
Tighten the captive screw on the bottom of the fan tray faceplate to secure it in the
3.
chassis, using a Phillips (+) screwdriver, number 2.
Chapter 22: Replacing TX Matrix Plus Hardware Components
Press here.
Press the release
latch on the top of
each rear fan tray
to install or remove
them.
345
Advertisement
Table of Contents
Troubleshooting
