Replacing An Acx500 Or Acx1100 Console Or Auxiliary Cable; Removing An Acx500 Or Acx1100 Console Or Auxiliary Cable - Juniper ACX1000 Hardware Manual

8. Verify that the status LEDs on the front panel indicate that the transceiver is functioning correctly.
For more information about the component LEDs, see the
Routers" on page 55.
SEE ALSO
Front Panel of an ACX1000 Router | 48
Uplink Ports on ACX1000 and ACX1100 Routers | 51

Replacing an ACX500 or ACX1100 Console or Auxiliary Cable

IN THIS SECTION

Removing an ACX500 or ACX1100 Console or Auxiliary Cable | 122

Installing an ACX1000 or ACX1100 Console or Auxiliary Cable | 123
Removing an ACX500 or ACX1100 Console or Auxiliary Cable
To remove a serial cable connected to a console or auxiliary device:
1. Attach an ESD grounding strap to your bare wrist, and connect the other end of the strap to an ESD
grounding point.
2. Press the tab on the connector, and pull the connector straight out of the CONSOLE/AUX port.
Figure 1 shows the connector.
3. Disconnect the cable from the console or auxiliary device.
Figure 29: Ethernet Cable Connectors
"LEDs on ACX1000 and ACX1100
122