Reinstalling The Txp-F2S Sibs; Figure 66: Reinstalling A Host Subsystem: Txp-Cb And Routing Engine - Juniper TX MATRIX PLUS Hardware Manual

TX Matrix Plus Router Hardware Guide

Reinstalling the TXP-F2S SIBs

150

Figure 66: Reinstalling a Host Subsystem: TXP-CB and Routing Engine

To reinstall the TXP-F2Ss (see Figure 67 on page 151):
CAUTION: Be prepared to support the weight of the TXP-F2S (approximately
35 lb [15.9 kg]) before you lift it.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Lift the TXP-F2S SIB into place and carefully align first the bottom, then the top of
2.
the TXP-F2S SIB with the guides inside the card cage.
Carefully slide the TXP-F2S SIB all the way into the card cage until you feel resistance.
3.
Copyright © 2010, Juniper Networks, Inc.