Removing A T4000 Console Or Auxiliary Cable - Juniper T4000 Hardware Manual

Removing a T4000 Console or Auxiliary Cable

Copyright © 2018, Juniper Networks, Inc.
To remove a serial cable connected to a management console or auxiliary device (see
Figure 91 on page 252):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the site ESD points on the chassis.
Turn off the power to the console or auxiliary device.
2.
Unscrew the screws that secure the cable connector to the port, using a 2.5-mm
3.
flat-blade screwdriver if necessary.
Pull the cable connector straight out of the port.
4.
Disconnect the cable from the console or auxiliary device.
5.
Chapter 27: Replacing Chassis Components
251