Troubleshooting Tx Matrix Plus Alarms; Deactivating Alarms On The Tx Matrix Plus Craft Interface - Juniper TX MATRIX PLUS Hardware Manual

Table 46: SONET/SDH Interface Alarm Messages (continued)
Craft Interface Message
interface-name so-x/x/x REI
interface-name so-x/x/x SEF
interface-name so-x/x/x UNEQ
Related
Documentation

Troubleshooting TX Matrix Plus Alarms

Deactivating Alarms on the TX Matrix Plus Craft Interface

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
CLI Message
interface-name so-x/x/x - SONET remote error indicator
interface-name so-x/x/x - SONET severely errored frame
interface-name so-x/x/x - SONET unequipped
TX Matrix Plus Craft Interface Overview on page 30
Deactivating Alarms on the TX Matrix Plus Craft Interface on page 279
Displaying TX Matrix Plus SFC and LCC Alarm Messages Information on page 280
Deactivating Alarms on the TX Matrix Plus Craft Interface on page 279
Displaying TX Matrix Plus SFC and LCC Alarm Messages Information on page 280
Deactivating an alarm turns off both LEDs and deactivates the device attached to the
corresponding alarm relay contact on the TXP-CIP. The LCD display continues to report
the alarm message until the condition that caused the alarm is cleared.
To deactivate red and yellow alarms:
Press the button labeled
1.
below the alarm LEDs.
Look at the LCD display for more information about the alarm or to confirm that the
2.
alarm has been cleared.
TX Matrix Plus Craft Interface Overview on page 30
TX Matrix Plus Troubleshooting Resources on page 276
Displaying TX Matrix Plus SFC and LCC Alarm Messages Information on page 280
Chapter 21: Troubleshooting TX Matrix Plus Hardware Components
(for "alarm cutoff/lamp test"), which is located
ACO/LT
279