Deleting The Upgrade Mode Statement; Connecting The Control Planes In An Operational T1600 Router - Juniper TX MATRIX PLUS Hardware Manual

Deleting the Upgrade Mode Statement

Related
Documentation

Connecting the Control Planes in an Operational T1600 Router

Copyright © 2010, Juniper Networks, Inc.
After all five TXP-T1600 SIBs have been installed, connected, and you have verified that
they are operational, delete the
Plus router and the T1600 router.
Delete the
1. fabric upgrade-mode
router at the
[edit chassis]
user@host# delete chassis fabric upgrade-mode
Delete the fabric upgrade-mode
2.
at the hierarchy level.
[edit chassis]
user@host# delete chassis fabric upgrade-mode
On both the TX Matrix Plus router and the T1600 router, verify that upgrade mode
3.
has been deleted.
user@host# show chassis fabric upgrade-mode
Commit the configuration on both the master and the backup Routing Engines.
4.
user@host# commit synchronize
Switching Plane Connections from the TX Matrix Plus Router to the T1600 Routers on
page 63
Overview of Preparing to Upgrade and Integrate an Operational T1600 Router on
page 199
Overview of Upgrading and Integrating an Operational T1600 Router on page 201
NOTE: The RJ-45 ports labeled
for future use.
To connect the control planes (see Figure 89 on page 220) between the TXP-CIP and
LCC-CBs on the T1600 router ports:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Plug one end of a UTP Category 5 cable into the RJ-45 LCC control plane port
2.
. The cable wiring is straight-through (not crossover).
TXP-CIP-0
Plug the other end of the cable into the port labeled
3.
T1600 router. Arrange the cable appropriately.
Plug one end of a UTP Category 5 cable into the RJ-45 LCC control plane port
4.
.
TXP-CIP-1
Chapter 16: Upgrading and Integrating an Operational T1600 Router
statement from both the TX Matrix
fabric upgrade-mode
statement in the configuration of the TX Matrix Plus
hierarchy level.
statement in the configuration of the T1600 router
through
SFC1
SFC0
on TXP-CIP are reserved
SFC3
0
on the LCC-CB-0 on the
0
on
on
219