Powering Off The Tx Matrix Plus Router - Juniper TX MATRIX PLUS Hardware Manual

Powering Off the TX Matrix Plus Router

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Connecting the TX Matrix Plus Router to a Network Device on page 158
TX Matrix Plus Preventing Electrostatic Discharge Damage on page 392
To power off the TX Matrix Plus router:
On an external management device connected to the Routing Engine, issue the
1.
system halt both-routing-engines
down the Routing Engines cleanly, so their state information is preserved. (If the TX
Matrix Plus router contains only one Routing Engine, issue the
command.) For more information about the command, see the Junos OS System
Basics and Services Command Reference.
user@host> request system halt both-routing-engines
Wait until a message appears on the console confirming that the operating system
has halted.
Halt the system ? [yes,no] (no) yes
*** FINAL System shutdown message from user@host ***
System going down IMMEDIATELY
Terminated
...
syncing disks... 11 8 done
The operating system has halted.
Please press any key to reboot.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Switch the circuit breakers on each power supply faceplate to the off position (
3.
TX Matrix Plus Seven-Input 420-A Power Supplies Overview on page 41
Connecting the TX Matrix Plus Router to a Network Device on page 158
Connecting the TX Matrix Plus Router to a Management Console or Auxiliary Device
on page 160
TX Matrix Plus Preventing Electrostatic Discharge Damage on page 392
Chapter 13: Grounding and Providing Power to the TX Matrix Plus Router
operational mode command. The command shuts
request
request system halt
).
O
173