Verifying The State Of The Links In The Routing Matrix - Juniper TX MATRIX PLUS Hardware Manual

TX Matrix Plus Router Hardware Guide
Related
Documentation

Verifying the State of the Links in the Routing Matrix

Purpose
258
1.2 V_ASF
1.2 V_ASF_B
1.2 V_ASF_D
1.5 V
1.8 V
3.3 V
3.3 V bias
3.3 V ASF
9.0 V
...
TX Matrix Plus TXP-F13 SIB Overview on page 13
TX Matrix Plus TXP-F13 SIB LEDs on page 15
TXP-F13 SIB LEDs on the TX Matrix Plus Craft Interface on page 34
Routing Matrix with a TX Matrix Plus Router Switch Fabric and Switching Plane
Architecture on page 60
Switching Plane Connections from the TX Matrix Plus Router to the T1600 Routers on
page 63
Troubleshooting the Switching Planes in the Routing Matrix on page 305
After the T1600 router has booted, verify the state of the links in the routing matrix.
Verify the state of the optical switch fabric links by issuing the
1.
command.
plane extensive
Verify that the state of each optical link is
user@host> show chassis fabric plane extensive
1195 mV
1195 mV
1198 mV
1498 mV
1804 mV
3300 mV
3300 mV
3292 mV
8250 mV
show chassis fabric
Links ok .
Copyright © 2010, Juniper Networks, Inc.