Replacing A Ptx5000 Management Console Or Auxiliary Port Cable; Removing A Management Console Or Auxiliary Port Cable; Figure 259: Installing A Routing Engine Into A Control Board - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide
Related
Documentation

Replacing a PTX5000 Management Console or Auxiliary Port Cable

Removing a Management Console or Auxiliary Port Cable

406

Figure 259: Installing a Routing Engine into a Control Board

PTX5000 Control Board Description on page 83
PTX5000 Control Board LEDs on page 87
Troubleshooting the PTX5000 Control Boards on page 524
Prevention of Electrostatic Discharge Damage on page 611
request system halt
Removing a Management Console or Auxiliary Port Cable on page 406
1.
Installing a Management Console or Auxiliary Port Cable on page 407
2.
To remove a cable from the console or auxiliary port (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Turn off the power to the console or auxiliary device.
2.
Pull the cable connector straight out of the port.
3.
Disconnect the cable from the console or auxiliary device.
4.
Figure 260 on page 407):
Copyright © 2017, Juniper Networks, Inc.