Juniper TX MATRIX PLUS Hardware Manual page 342

TX Matrix Plus Router Hardware Guide
Related
Documentation
308
Port 0
Port 1
Port 2
Port 3
SG 1
Port 0
Port 1
Port 2
Port 3
SG 2
Port 0
Port 1
Port 2
Port 3
SG 3
Port 0
...
Display the system log messages to obtain information about link failures. The
3.
file is a commonly configured destination for system log messages.
/var/log/messages
To display it, issue the show log
user@host> show log messages
For more information about system log messages, see the Junos OS System Log
Messages Reference.
Your customer support representative can assist you with using the information in
the system log, along with the supplied fiber-optic array loopback connector and
adapter, to determine if you have a faulty TXP-F13 SIB, TXP-T1600 SIB, or fiber-optic
array cable.
CAUTION: Do not connect and disconnect a fiber-optic array cable
connector, a loopback connector, or a loopback adapter more frequently
than required to perform the procedures in this hardware guide. These
fiber-optic components are rated for a limited number of insertions
(approximately 100).
TX Matrix Plus Craft Interface Overview on page 30.
Switching Plane Connections from the TX Matrix Plus Router to the T1600 Routers on
page 63
Cleaning Fiber-Optic Array Components with the Dry Cloth Cleaning Tool on page 271
Replacing a TXP-F13 SIB on page 366
Replacing a TXP-F2S SIB on page 370
: Links ok
: Links ok
: Links ok
: Links ok
: Links ok
: Links ok
: Links ok
: Links ok
: Links ok
: Links ok
: Links ok
: Links ok
: Links ok
command. For example:
Copyright © 2010, Juniper Networks, Inc.