Installing An Optional Sfp Transceiver Into The Switch; Connecting To A Power Source; Inserting An Sfp Transceiver Into A Slot - Alcatel OS-LS-6248 Getting Started Manual

3.
4.

Installing an Optional SFP Transceiver into the Switch

To install an SFP transceiver, do the following:
1.
2.
3.
Note: SFP transceivers are hot-swappable. The switch does not need to be powered off

Connecting to a Power Source

To connect a device to a power source:
1.
Downloaded from www.Manualslib.com
are at least two inches of space on all sides for proper air flow.
If installing a single switch only, go to "Connecting to a Power Source" at the
end of this chapter.
If installing multiple switches, attach four adhesive feet to each one. Place each
device squarely on top of the one below, in any order.
Figure 2-5. Inserting an SFP Transceiver into a Slot
Consider network and cabling requirements to select an appropriate SFP
transceiver type.
Insert the transceiver with the optical connector facing outward and the slot
connector facing down. Note that SFP transceivers are keyed so they can only
be installed in one orientation.
Slide the SFP transceiver into the slot until it clicks into place.
before installing or removing a transceiver. However, always first disconnect the
network cable before removing a transceiver.
Insert the power cable plug directly into the receptacle located at the back of
the device.
manuals search engine
Connecting to a Power Source
2
2-17