Figure 51 Device Operation > Device Configuration > Security > Firewall > Rule Summary - ZyXEL Communications Centralized Network Management Vantage CNM User Manual

Chapter 6 Device Security Settings
Figure 51 Device Operation > Device Configuration > Security > Firewall > Rule Summary
The following table describes the labels in this screen.
Table 41 Device Operation > Device Configuration > Security > Firewall > Rule Summary
LABEL
Direction Summary
Packet Direction
ACL Rule Set Parameters for
Packet Direction Chosen
Log packets that don't match
these rules.
Action for packets that don't
match firewall rules
Apply
Reset
112
DESCRIPTION
Firewall rules are grouped based on the direction of travel of packets to
which they apply. Select a direction from the drop-down list box.
Use the drop-down list box to select a direction of travel of packets for
which you want to configure firewall rules.
Select the check box to create a log (when the above action is taken)
for packets that are traveling in the selected direction and do not match
any of the rules below.
Select what action the device should take for packets that don't match
any of the firewall rules you configured.
Select Drop to silently discard the packets without sending a TCP reset
packet or an ICMP destination-unreachable message to the sender.
Select Reject to deny the packets and send a TCP reset packet (for a
TCP packet) or an ICMP destination-unreachable message (for a UDP
packet) to the sender.
Select Permit to allow the passage of the packets.
Click Apply to save your changes back to the device.
Click this to reset this screen to its last saved values.
Vantage CNM User's Guide