State Of The Pin During Standby Mode, Hold, And Reset - Fujitsu F2MC-16LX Hardware Manual

CHAPTER 6 LOW-POWER CONSUMPTION MODE
6.7

State of the Pin during Standby Mode, Hold, and Reset

The state of the pin at the time of the stand by mode, the hold, or the reset is shown for
each memory access code.
Pin State in Single-chip Mode
Table 6.7-1 shows the state of the pin in the single-chip mode.
Table 6.7-1 Pin State in Single-chip Mode
Pin Name
P07 to P00
P17 to P10
P27 to P20
P37 to P30
P47 to P40
The state immediately
P57 to P50
before hold
P77 to P70
P87 to P80
P96 to P90
PA7 to PA0
PB6 to PB0
P67 to P60
Possible to input
DVP
DVM
USB port input
HVP
HVM
VBUS Input state
The state immediately
HCON
before hold
*1: Same as the other ports if this is being used for the output state. "Input enabled" means that the input function is
currently enabled; Pull-up/Pull-down or an input from the external is required.
*2: Outputs the initial output preceding this mode. Alternatively, this means "Input disabled" if the signal is input. "Input
disabled" means that the contents of a pin are not accepted internally, because the internal circuit is not in operation
although operation of the input gate nearest to the pin is currently enabled.
162
At sleep
SPL=0
Input cutoff/
The state
immediately
*2
before hold
*2,*3
*1
Possible to input
USB port input
Input cutoff
Hold state preserved
In stop mode
SPL=1
Input cutoff/
output Hi-Z
*3
*1
*4
At holding At a reset
Impossible to
This state does
input/output Hi-Z
not exist.
Impossible to input
Hi-Z
*5
Input state
"H" output