Page 1
FUJITSU SEMICONDUCTOR SS01-44005-1E SUPPORT SYSTEM MC-16LX LQFP-48P PROBE CABLE (NQPACK VERSION) MB2132-466 OPERATION MANUAL...
Page 3
(2) for use requiring extremely high reliability (i.e., submersible repeater and artificial satellite). Please note that Fujitsu will not be liable against you and/or any third party for any claims or damages arising in connection with above-mentioned uses of the products.
1. Checking packed components Before using the MB2132-466, make sure the following components have been provided. • • • • MB2132-466 (LQFP-48P Probe Cable): 1 • • • • Screws for securing probe header (M2 x 14 mm with washer): 4 •...
Page 5
• • • • The probe cable is not very flexible sideways. To avoiding placing extra stress on the probe cable, consideration must be given to the location of the emulator relative to the user system, and the emulator's orientation. •...
Page 6
3. Mounting Mass-produced MCUs To mount a mass-produced MCU on the user system without connecting an emulator, use the socket cover (HQPACK048SD) that is supplied with the probe cable. To mount a mass-produced MCU on the user system, place the mass-produced MCU on the user system by aligning the first pin (L) of the NQPACK mounted on the user system with the first pin (G) of the pass-produced MCU as shown in Figure 3-1.
Page 9
SS01-44005-1E FUJITSU SEMICONDUCTOR • SUPPORT SYSTEM MC-16LX LQFP-48P PROBE CABLE <NQPACK VERSION> MB2132-466 OPERATION MANUAL February 2002 the first edition FUJITSU LIMITED Electronic Devices Published Edited Technical Information Dept.