Fujitsu F2MC-16LX Hardware Manual page 378

CHAPTER 15 PWC TIMER
[bit 5, bit 4] PIS1, PIS0 (pulse width measurement input terminal selection)
The pulse width measurement input terminal is selected.
Table 15.2-4 Selection of Pulse Width Measurement Input Terminal
PIS1
0
0
1
1
• Initialized to 00
• Read and write are enabled. However, do not set "01
Note:
Rewriting after the startup is an interdiction. Always perform the write operation before start or after
stop.
[bit 3] S/C (Measurement mode (single/continuous) selection)
The measurement mode is selected.
Table 15.2-5 Selection of Measurement Mode of 16-bit Up-count Timer
S/C Measurement mode selection
Single measurement mode
0
[Initial value]
1 Continuous measurement mode
• Initialized to "0" at reset.
• Reading and writing are allowed.
Note:
Rewriting after the startup is an interdiction. Always perform the write operation before start or after
stop.
362
PIS0
0 (The terminal PWC is selected). [Initial value]
1 Setting disabled
0 Setting disabled
1 Setting disabled (Undefined)
at reset.
B
Reload none (single shot)
There is reload (reload timer).
Operation mode
", "10
B B
At timer mode
Stop after one measurement
Continuous measurement:
buffer register enabled
", and "11 ".
B
Pulse width