Commands In The Autolearn Mode; Start - Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.5 Port Access Control List Locked Ports
11.5.4

Commands in the AUTOLEARN mode

This section describes commands that you can call up in the AUTOLEARN mode.
In the Global configuration mode, enter the
● If you exit the AUTOLEARN mode with the
● If you exit the AUTOLEARN mode with the
11.5.4.1

start

Description
With this command, you start automatic learning. During automatic learning, the aging time
is disabled for all learned addresses.
Requirement
You are in the AUTOLEARN mode.
The command prompt is as follows:
cli(config-auto-learn)#
Syntax
Call the command without parameters:
start
Result
The learned MAC addresses are entered in the port database with the aging time 0 (the
entries are NOT deleted when the mac address aging time expires).
Further notes
You stop automatic learning with the
518
configuration mode.
EXEC mode.
command to change to this mode.
auto-learn
command, you return to the Global
exit
command, you return to the Privileged
end
command.
stop
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07