No Interface - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.5 VRRP
The parameters have the following meaning:
Parameter
vlan
vlan-id
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
Result
You are in the VRRP Interface Configuration mode.
The command prompt is as follows:
cli(config-vrrp-if)#
Further notes
You exit the Interface Configuration mode with the
You delete a VRRP interface with the
You display the status and the configuration of the VRRP interfaces with the
interface show vrrp interface - vrid
9.5.4.2

no interface

Description
With this command, you delete a VRRP interface.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Router Configuration mode.
The command prompt is as follows:
cli(config-vrrp)#
436
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Slot no. and port no. of the interface
no interface
command.
Values
-
1 ... 4094
•
•
Enter a valid interface name
or command.
end exit
command.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
gigabitethernet
extreme-ethernet
show vrrp