Commands In The Global Configuration Mode; Router Vrrp - Siemens SCALANCE XM-400 Configuration Manual

The parameters have the following meaning:
Parameters
vlan
VlanId
interface-type
interface-id
vrID
brief
detail
statistics
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
Result
The settings of the virtual router are displayed.
9.5.3

Commands in the Global Configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
9.5.3.1

router vrrp

Description
With this command, you enable routing with VRRP and change to the VRRP Router
Configuration mode.
Note
This command is available only with layer 3.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Slot no. and port no. of the
interface.
ID of the virtual router
shows brief information on VRRP
shows detailed information on
VRRP.
shows the statistics of the VRRP
protocol
configure terminal
Range of values
-
1 ... 4094
•
gigabitethernet
•
extreme-ethernet
Enter a valid interface name
1 ... 255
-
-
-
command to change to this mode.
or command and are then in the
end exit
Layer 3 functions
9.5 VRRP
433