Commands In The Global Configuration Mode; Nfc Active - Siemens SCALANCE XM-400 Configuration Manual

3.6.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
3.6.2.1

nfc active

Description
With this command, you activate NFC.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
nfc active
Result
NFC is activated.
Further notes
You deactivate NFC with the
You display the status, i.e. whether the NFC function is activated or deactivated with the
command
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
no nfc active
show nfc active status
command to change to this mode.
configure terminal
or
end exit
command.
.
Configuration
3.6 NFC (SCALANCE XM400 only)
command and are then in the
103