Show Ip Ospf Interface - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv2
cli>
Syntax
Call the command without parameters:
show ip ospf border-routers
Result
The routes are displayed.
9.3.6

show ip ospf interface

Description
This command shows the information on the OSPF interface.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip ospf interface
[{
vlan<vlan-id(1-4094)>|<interface-type><interface-id>
}]
The parameters have the following meaning:
Parameters
Vlan
vlan-id
interface-
type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
If you do not select any parameter from the parameter list, the information is displayed for all
available interfaces.
364
or
cli#
or
cli#
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Slot no. and port no. of the interface
Values
-
1 ... 4094
•
gigabitethernet
•
extreme-ethernet
Enter a valid interface name
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07