No Ip Ospf Dead-Interval - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface
Hide thumbs Also See for SCALANCE XM-400:
Table of Contents

Advertisement

Result
The interval is specified.
Further notes
You delete the interval with the
You show the configuration of the OSPF interface with the
command.
9.3.14.8

no ip ospf dead-interval

Description
With this command, you delete the interval.
Note
This command is available only with layer 3.
Requirement
● The interface is a layer 3 interface.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no ip ospf dead-interval
Result
The interval is deleted.
Further notes
You specify the interval with the
You show the configuration of the OSPF interface with the
command.
You configure the router port with the
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
command.
no ip dead-interval
command.
ip dead-interval
command.
no switchport
Layer 3 functions
9.3 OSPFv2
show ip ospf interface
show ip ospf interface
405

Advertisement

Table of Contents
loading

This manual is also suitable for:

Scalance xr-500

Table of Contents