No Standby Port - Siemens SCALANCE XM-400 Configuration Manual

Further notes
You disable the setting with the
You display the status of this function and other information
8.4.6.7

no standby port

Description
With this command, disable the port for a standby connection on a device.
Requirement
You are in the Redundancy Configuration mode.
The command prompt is as follows:
cli(config-red)#
Syntax
Call up the command with the following parameters:
no standby port {<iftype> <ifnum>}
The parameters have the following meaning:
Parameter
<iftype>
<ifnum>
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
Result
The ports for a standby connection are disabled.
Further notes
You enable the setting with the
You display the status of this function and other information
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
no standby port {<iftype> <ifnum>}
Description
Type of interface
Slot no. and port no. of the interface
standby port {<iftype> <ifnum>}
Layer 2 management protocols
8.4 Ring redundancy and standby connection
command.
show ring-redundancy
Range of values
•
gigabitethernet
•
extreme-ethernet
Enter a valid interface name
command.
show ring-redundancy
.
.
343