No Monitor Session Source - Siemens SCALANCE XM-400 Configuration Manual

Diagnostics
12.4 Port Mirroring
12.4.4.8

no monitor session source

Description
With this command, you delete the source for mirroring a port or a VLAN.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command for the port to be monitored with the following parameter assignment:
no monitor session<session-id(1-7)>{source
{interface<interface-type><interface-id>[{rx|tx|both}]}
or
Call up the command for the VLAN to be monitored with the following parameter assignment:
no monitor session <session-id (1-1)> {source
{vlan <vlan-id> | mac-acl <acl-id>}
The parameters have the following meaning:
Parameter
session-id
interface
interface-
type
interface-id
rx
tx
both
vlan-id
acl-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
If you do not select any parameters from the parameter list, the default value (both) is used.
590
Description
Number of the session
7 parallel sessions are possible only with port-based
mirroring and their ports must not overlap.
Keyword for a an interface description
Type or speed of the interface
Slot no. and port no. of the interface
Received data traffic will be mirrored (received)
Transmitted data traffic will be mirrored (transmitted) -
Received and sent data traffic will be mirrored
Number of the VLAN
Number of the Access Control List
Values
1 .. 7
-
•
•
Enter a valid interface name
-
-
1 .. 4094
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
fastethernet
gigabitethernet