Commands In The Interface Configuration Mode; Vrrp Associated-Ip - Siemens SCALANCE XM-400 Configuration Manual

9.5.5

Commands in the Interface Configuration mode

This section describes commands that you can call up in the Interface Configuration mode.
Note
The commands are only available with layer 3 and when the interface is a VLAN interface.
In the Interface Configuration mode, enter the
Commands relating to other topics that can be called in the Interface Configuration mode
can be found in the relevant sections.
● If you exit the Interface Configuration mode with the
● If you exit the Interface Configuration mode with the
9.5.5.1

vrrp associated-ip

Description
With this command, you specify which IP addresses the virtual router monitors.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Interface Configuration mode.
The command prompt is as follows:
cli(config-vrrp-if)#
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> associated-ip <ip_addr>
The parameters have the following meaning:
Parameter
vrid
ip_addr
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Interface Configuration mode.
Privileged EXEC mode.
Description
ID of the virtual router
Value for an IP address
command to change to this mode.
interface
command, you return to the
exit
command, you return to the
end
Range of values
1 ... 255
specify a valid IP address
Layer 3 functions
9.5 VRRP
439