Ntp Server - Siemens SCALANCE XM-400 Configuration Manual

5.2.3.1

ntp server

Description
With this command, you configure the connection to a server on the NTP client.
Requirement
You are in the NTP configuration mode.
The command prompt is as follows:
cli(config-ntp)#
Syntax
Call up the command with the following parameters:
ntp server{ipv4 <ip_addr> | fqdn-name <FQDN(100)>}[port<123,1025-
36564>][poll<seconds(64-1024)>]
The parameter has the following meaning:
Parameter
ipv4
ip_addr
fqdn-name
FQDN(100)
port
poll
seconds
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 30)".
Result
The connection to a server is configured on the NTP client.
Further notes
You delete the connection to a server with the
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Keyword for an IPv4 address
Value for the IPv4 address of the time server
Keyword for a domain name
Domain name (Fully Qualified Domain Name)
UDP port of the time server
Keyword for the time after which the time of day is
requested again
Value for the time in seconds
Range of values / note
-
Enter a valid IPv4 address
-
Maximum of 100 characters
123
•
1025 ... 36564
•
Default: 123
-
64 ... 1024
command.
no ntp server
System time
5.2 NTP client
125